Components
This high performance, low power AVR® 8-bit microcontroller (ATMEGA168-20PU) is programed with the Arduino boot loade...
These are standard 7805 regulators good for 1 amp. They have a dropout voltage of around 2.5 volts so require a minim...
We wanted to provide some resistors as a convenience for beginners to get going.
We’re offering approximately f...
The LM2940 is a common low-dropout (LDO) linear regulator. A regulator's dropout voltage is the voltage required betw...
We located a 40 pin double-male header that works well in the BBB with a standard header length below the circuit boa...
Snap-off double-row male headers that we use on the ICSP header of the BBB. Gold plated.
They are grooved but the thi...
Female headers (sockets). Spaced on .100" centers. Cut them on a pin, not between pins, so you lose a pin with e...
40 pin snap-off headers on .100" centers. Cut them, or snap them off between pins with no losses. Gold plated. B...
Snap-off right angle headers that we use on the programming header of the BBB. Cut them between pins with no losses. ...
The shortage in Atmega328 chips is over, at least here at Modern Device. We have programmed Atmega328p ch...
The most common value of capacitor useful for bypassing, and a range of beginning experiments with Arduino / Freeduin...
The TIP 120 is a NPN darlington transistor with a current gain of 1000 that is a good choice for interfacing many hig...
These resonators save a little hassle and space in building your own breadboard or protoboard Arduino clones. They’re...
Three pin female headers – 10 pack. Spaced on .100" centers. Great for interfacing sensors to proto boards...
This pack contains 10 six-pin male headers & 10 six-pin female headers. They are perfect for interfacing JeeNodes...