Components
The CUI GF0661 8 ohm, .5 watt speaker fits perfectly in a low-cost, readily accessible enclosure, (a styrofoam cup), ...
These are the sockets we use on BBB, RBBB and JeeNode kits.
28 pins - what else can we say. Try to get the little "di...
This protoboard was suggested for use in our physical computing classes by a colleague. It is a copy of a "solderless...
These 40 pin sockets fit the Sanguino chips.
Try to get the little "divot" on the socket into the board in the correc...
The are the power jacks we use on BBB's and RBBB's. The Sanguino uses a different model with wider pins. Sold in sing...
This adapter converts a standard 1/8th inch female connector on one end to a standard 1/4th inch male connector on th...
These are sturdy ABS clam shell plastic boxes that snap together very securely. The clam-shell halves of the box are ...
Just the Sanguino Chip (Atmega 644P) programmed with the Sangunio Bootloader and Blink Sketch. Useful for breadboard ...
Here are some N-channel high power MOSFET's useful for driving higher voltages and currents from a microcontroller. T...
The L298 is a classic dual h-bridge chip. It is capable of driving motors at 2 amps continuous output, and 3 am...
The A6279 chips are chips specifically designed for driving LED display
applications. Each of these BiCMOS dev...
The UART Plug contains a hardware serial
port with 64-byte buffers for both sending and receiving. It can support...
Standard terminal blocks with 3.5mm (.138") pitch. Handy for connecting terminal wires where higher currents or...
These are handy connectors for connecting wires to a printed circuit board. They do not clip together but can be dais...
This is a standard analog servo, with nylon gears and metal ball bearings on the output shaft. It runs at voltages fr...